The build is a developer preview and carries the build number YU5040_SW_V-DEV-PREW-01_HW_V01_20170531 and weighs in at 667 MB. It goes without saying that you should be on a stock ROM running the latest developer build in order to use the latest update. After the update, you may see some performance and battery enhancements.
DISCLAIMER
PRE-REQUISITES
This Update is only for Yureka Black only. We recommend to take complete backup and proceed. Maintain 50-60% battery to prevent sudden shutdown between the process.
Downloads
Yu Yureka Beta Nougat 7.1.2 Beta build | Download GApps ARM 64 | Download ADB & Fastboot Driver For Windows | Download Unlocked Bootloader | Guide TWRP Recovery | Download
Steps to install official Android 7.1.2 Nougat Beta On Yureka Black –
Extract the downloaded Firmware package on your PC. Connect your device in ADB Interface Open Command Prompt and enter the following command to enter Fastboot mode
Navigate to extracted firmware folder YU5040_SW_V-DEV-PREW-01_HW_V01_20170531
If the host OS of your PC is Linux/Ubuntu run the following command: flash-linux.sh If using Windows OS: flash-windows.bat Once the device is booted up, reboot into fastboot mode. Enter the command: fastboot boot /path/of/your/Twrp_image downloaded Install GApps by rebooting into TWRP recovery Clear cache and reboot your device.
This completes the Installation of Android Nougat 7.1.2 Developer Preview on Yu Yureka Black. Note: Do not perform this procedure unless you are using an Unlocked Bootloader. In case you have any queries, comment down below.
